Hunter 23252 Owner's Manual - Page 5

2 • Installing the Hanger Bracket 2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box, using the ceiling plate as a guide. The pilot holes should be 9/64" in diameter. 2-2. Install one canopy screw into each side of the ceiling plate as shown. 2-3. Place a flat washer on each of the two 3" wood screws. 2-4. Thread the lead wires from the outlet box down through the hole in the middle of the ceiling plate. 2-5. Align the slotted holes in the ceiling plate with the pilot holes you drilled in the wood support structure. 2-6. Pass the wood screws through the slotted holes in the hanger bracket into the pilot holes you drilled. Tighten the wood screws into the 9/64" pilot holes; do not use lubricants on the screws. Do not over tighten. Step 2-1 Canopy Screw Flat Washer Step 2-2 3" Wood Screw 5 41081-01 • 08/04/09 • Hunter Fan Company