Hunter 23781 Owner's Manual - Page 12

7 • Completing Your Installation With or Without a Light Fixture Steps 7-1 - 7-3 Housing Assembly Screw Upper Switch Housing 7-1. To attach the upper switch housing, partially install two #6-32 x 3/8" housing assembly screws into the switch housing mounting plate. 7-2. Feed the upper plug connector through the center opening of the housing. 7-3. Align the keyhole slots in the housing with the housing assembly screws. 7-4. Turn the housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots. Install the remaining #6-32 x 3/8" screw into the housing. Tighten all three screws firmly. CAUTION: Make sure the upper switch housing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three assembly screws could result in the switch housing and light fixture falling. Your Hunter fan comes with an integrated light fixture assembly and an optional switch housing cap and plug button. This feature gives you the option of installing the fan with OR without the included light fixture. If you want to install the light fixture, proceed with step 7-5 now. If you do not want to install the light fixture, you need to uninstall it now. See "Uninstalling the Light Fixture" on page 12. WARNING: Use only the light fixture supplied with this fan model. Note: In compliance with US federal energy regulations, this ceiling fan contains a device that restricts its light output. Exceeding the wattage limit marked on the MAX wattage sticker affixed to the light socket(s) may result in fire hazard or improper operation. If lights do not appear to be operating properly, see the troubleshooting section. 12 42609-01 • 01/12/11 • Hunter Fan Company