Hunter 23781 Owner's Manual - Page 8

3 • Assembling the Fan Standard or Angle Mounting Steps 3-2 - 3-3 WARNING: Fan may fall if not assembled as directed in these installation instructions. 3-1. Unbundle the wires from the fan. Downrod For Standard or Angle mounting: 3-2. Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball. Set Screw Canopy Canopy Trim Ring 3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Go to 4 • Hanging and Wiring the Fan. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. For Low Profile mounting: Low Profile Mounting Steps 3-5 - 3-6 Low Profile Screws Note: For low profile mounting, the downrod is replaced with the low profile washer. 3-4. Remove the set screw from the adapter. Green Ground Wire Low Profile 3-5. Place the low profile washer into the canopy with the lip down. Washer 3-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. Go to 4 • Hanging and Wiring the Fan. Canopy Trim Ring Canopy Step 3-6 (Detail) Adapter Low Profile Screw Low Profile Screw Low Profile Washer 8 42609-01 • 01/12/11 • Hunter Fan Company