Hunter 23958 Owner's Manual - Page 7

2 • Installing the Hanger Bracket CAUTION: To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel. 2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. The pilot holes should be 9/64" in diameter. Hanger Bracket Canopy Screw 2-2. Partially install two canopy screws in the holes on each end of the hanger bracket, as shown in the figure to the right. 2-3. Your fan comes with four mounting isolators. Position the isolators between the hanger bracket and ceiling by inserting the raised areas on each isolator into the holes in the hanger bracket. 2-4. Thread the lead wires from the outlet box down through the hole in the middle of the hanger bracket. Isolator 2-5. Align the slotted holes in the hanger bracket with the pilot holes you drilled in the wood support structure. Note: The isolators should be flush against the ceiling. 2-6. Place a flat washer on each of the two 3" wood screws and pass the screws through the slotted holes in the hanger bracket into the pilot holes you drilled. Tighten the screws into the 9/64" pilot holes; do not use lubricants on the screws. Do not over tighten. Flat Washer 3" Wood Screw 7 42884-01 • 11/05/09 • Hunter Fan Company Step 2-2 Canopy Screw Step 2-3 Steps 2-4 - 2-6