Hunter 28111 Operation Manual - Page 8

Step 5-1 Tab Groove Step 5-2 Step 5-3 5 • Installing the Canopy 5-1. Rotate the hanger ball so the tab in the canopy is secure in the groove in the hanger ball. WARNING: Failure to complete this step could cause fan to fall. 5-2. Lift the fan and align the canopy screw holes with the mounting holes on the ceiling plate. 5-3. Partially install a canopy screw into the side opposite the ceiling plate tabs. 5-4. Partially install another canopy screw into the hole between the two ceiling plate tabs. Securely tighten both screws. 5-5. Using both hands, push the canopy trim ring up to the top of the canopy. The canopy trim ring will snap and lock into place. Should you need to remove the canopy trim ring, follow these steps: 1. Locate the tab indicators, small bumps on top of tabs. 2. Press firmly on opposite sides of the ring toward the canopy. The tabs will flex out releasing the trim ring from the canopy. Step 5-4 Step 5-5 8 41467-01 • 09/30/09 • Hunter Fan Company