Hunter 30756 Owner's Manual - Page 12

Air Purifier Maintenance Hook Tape Pre-Filter Hook Tape Fig. 11 6. Place the front grill back onto the unit. First, line up the tab on the bottom of the grill with the recess on the purifier base and then push the top of the grill forward until it is closed. Refer to Figs. 6 and 7 (pg. 7). NOTE: This unit will not operate unless the grill is in the correct position. 7. Plug in the air purifier. 8. Finally, reset the Pre-Filter Counter by pressing the Pre-Filter Reset key for 2 seconds. The Pre-Filter Counter will return to 100% and the Pre-Filter indicator will stop flashing. Cleaning the Filter The PermaLife™ Filtration System uses a cleanable filter that never has to be changed, only cleaned. When the filter exceeds 2800 hours (approximately 4 to 6 months of use), the Filter Life Counter will display 0% life remaining and the Filter indicator will flash (refer to Filter Life Counters for additional information, pg. 9). This is a reminder that you should check the filter and clean if necessary. The proper time to clean the filter depends on usage and the environment. Use the following list to help determine if the filter should be cleaned: • Compare the color of the filter to the color coded chart on the inside of the housing. If the filter color matches the darkest color on the chart, you should clean the filter. • If you notice a decrease in air output or an increase in noise at any time during normal operation, the filter may be clogged. Clean the filter to return to normal operation. To clean the filter and reset the Filter Life Counter: 1. First, turn off and unplug the air purifier. 2. Next, remove the front grill. Place your fingers under the handle on the grill and pull forward, then up. Refer to Figs. 4 and 5 (pg. 6). 41558-01 12