Hunter 34357 Owner's Manual - Page 6

Using Your Humidifier 1. Remove The Care Free® Humidifier Plus Evaporative Humidifier from its packaging. Read and Save the Instructions. 2. Place the humidifier on a hard, flat, water resistant surface. Always place the humidifier at least six (6) inches away from walls and sources of heat. 3. Lift the main housing to confirm that the PermaWick™ filters are placed upright in the slots. Replace the main housing. (See Figure 1.) 4. Remove the water tank and take it to the sink or tub to fill. 5. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Fill the water tank with cool water and replace the tank cap (Never use hot water). Be sure not to overfill the tank as water damage may occur to furniture or flooring due to spillage. HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE TO PROPERTY CAUSED BY WATER SPILLAGE. 6. Carry the tank back to the humidifier. Turn the tank upright and place it on the humidifier. Be sure that the tank is seated properly in the base. If the tank is properly located on the base, you will see air bubbles flowing up into the tank. 7. With the power control knob in the 'OFF' position, plug the humidifier into the wall. CAUTION: Never plug in the Humidifier while your hands are wet as Electric Shock could occur. 8. Use the power/speed control knob to turn the humidifier 'ON' by selecting a speed setting. Only for models with Automatic Shut-off 9. When the water tank is empty, the humidifier will automatically shut itself off. The red light will be illuminated, indicating that the water tank needs to be refilled. 10. Follow REFILLING THE WATER TANK directions. Once the water tank is refilled, the Refill Light will not be illuminated. Only for models with a NiteGlo™ Night Light 11. Use the control to turn the night light off and on. The night light can be operated even if the humidifier fan is turned 'OFF'. 41574-01 10/14/2002 6 © 2002 HUNTER FAN CO.