Hunter 34357 Owner's Manual - Page 7
Using Your Digital Humidistat - humidifiers
View all Hunter 34357 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Using Your Digital Humidistat Setting the Desired Humidity Note: After unplugging the humidifier to move the humidifier, to refill the water tank or to clean the humidifier, you must reset the digital humidistat. Refer to Figure 6. 1. Use the power/speed control knob to turn the humidifier 'ON' by selecting a speed setting. Note: A speed setting must be chosen before the humidistat will operate the humidifier. 2. In normal mode use the humidistat control buttons to set the desired humidity level. The settings range from 30% to 80% in 5% increments. 3. When the humidity exceeds the level you have set, the humidistat light will go off. The humidifier will not output humidity while the humidity in the room is at the selected humidity level. The humidistat light will stay off until the humidity changes. When the humidity in the room drops below the selected level, the humidifier will cycle on again and the humidistat light will come on. Setting the Span Refer to Figure 7. Your humidistat is set at the factory to cycle at setting 2. If you find your system cycling too fast or too slow, then the Span can be adjusted to modify the cycle time. 4. Press and hold both humidistat control buttons for two seconds to enter span setting mode. 5. In span mode, use the humidistat control buttons to adjust the span. Raise the span to 3 to increase the cycle time and allow your system to run longer. Lower the span to 1 to decrease the cycle time and allow your system to run shorter. 6. The humidistat display will return to normal mode after keys are idle for 5 seconds. Humidistat Light Humidistat Control Buttons Figure 7 Humidistat Control Buttons Figure 6 41574-01 10/14/2002 7 © 2002 HUNTER FAN CO.