Hunter 34407 Instruction Manual - Page 3
Using Your Humidifier
View all Hunter 34407 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
NiteGlo™ LED Display Control Panel Refill Tank LED (Red) Tank Tote Timer Power Humidity Speed Figure 3 Figure 2 Power: Turns the humidifier on and off. the power should always be off before unplugging the humidifier, moving the humdifier, or refilling the water tank. Water Tank Cap (under Tank) Twist to open Refill Light: The red LED turns on to signal that the humidifier has automatically turned off and the Water Tank needs to be refilled. Humidity: Enables you to set the desired maximum humidity level. Once this level is reached, the unit will automatically shut off until the humidity level drops. NOTE: The humidifier may not be running because the Span Setting may need to be adjusted. Speed: Sets the humdifier's fan speed to Low (1), Medium (2), or High (3). Figure 4 Timer: Sets the humidifier to run for 2, 4, 8, or 10 hours. when the timer is not used, the humidifier will run and cycle automatically. 5. Fill the Water Tank with water, return the Water Tank Cap to its position and tighten it, and return the Water Tank to the Tray. Using Your Humidifier Basic Set-Up and Operation 1. Remove the Hunter® Evaporative Humidifier from its packaging. 2. Place the humidifier on a hard, flat, water resistant surface. Always place the humidifier at least six (6) inches away from walls and sources of heat. 3. Grasp the Water Tank by its Tank Tote and remove it from the Tray. See Figure 3. 4. Turn the Water Tank upside-down and remove the Water Tank Cap. See Figure 4. 6. Plug the humidifier's Power Cord into a standard household power outlet. 7. Press the Power Button on the Control Panel. 8. To see the current humidity, press the Humidity button. To change the humidity, press and hold the Humidity button for 3 seconds. The LED Display will flash the current humidity setting. Press the Humidity button until the LED Display shows your desired humidity setting. You can change the setting in 5% increments from 30% relative humidity to 80%. When the LED Dispaly shows your desired humidity setting, release the Humidity button. After 2 seconds, the humidity setting is set and the LED Display will show the relative humidity. 9. To see the current Fan speed setting, press the Speed button. To change the Fan speed setting, press and hold the Speed button for 3 seconds. The LED Display will flash the ©2008 Hunter Fan Co. 3 43002 Rev 04-29