Hunter 34407 Instruction Manual - Page 4
Features and Options, Humidifier Maintenance - humidifier parts
View all Hunter 34407 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
current Fan speed setting. Press the Speed button until the LED Display shows your desired Fan speed setting, Low (1), Medium (2), or High (3). Release the Speed button. After 2 seconds, the Fan speed is set and the LED Display will show the relative humidity. 10. During normal operation, the LED Display will show the relative humidity of the space in which you place your humidifier. The NiteGlo™ Night Light Press the NiteGlo™ button on the Control Panel to turn the night light on and off. NOTE: The NiteGlo™ night light is inoperable when the humidifier is turned off. Refilling The Water Tank Features and Options Automatic Shut-Off When the Water Tank is empty, the humidifier will automatically turn off and the red Refill Tank LED will turn on. The Refill Tank LED will turn off when the Tank is refilled and placed back on the humidifier. Timer You can set your humidifier to run for pre-set periods of time. 1. When the water tank level is low, turn the humidifier 'OFF', and unplug. 2. Remove the tank and take it to the sink or tub to refill. 3. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Empty the tank, refill with fresh cool water (never use hot water), and replace the tank cap. Be sure not to overfill the tank as water damage may occur to furniture or flooring due to spillage. HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE TO PROPERTY CAUSED BY WATER SPILLAGE. 1. To see the current Timer setting, press the Timer button once. 2. To change the Timer setting, press the Timer button and hold it for 3 seconds. The current Timer setting will begin to flash. 3. Press the Timer button again to change the setting. The settings in hours are OF (Off), 2, 4, 8 and 10. 4. When the LED Display shows your desired run time, release the Timer Button. After 2 seconds, the run time is set and the LED Display will show the relative humidity. 5. The humidifier will shut down automatically when the set time expires. 4. Carry the tank back to the humidifier. Turn the tank upright and place it on the humidifier. Be sure that the tank is seated properly in the Tray. If the tank is properly located on the Tray, you will see air bubbles flowing up into the tank. Humidifier Maintenance Many regions have hard water with high concentrations of minerals. When water evaporates from The Hunter® Evaporative Humidifier, minerals may be left behind. These minerals can form a hard white scale which can be removed by following the cleaning instructions. The frequency of cleaning due to mineral build up can vary depending upon the quality of water you may have. Refer to Figure 1 for part names. Span Setting 1. Turn the humidifier 'off' and unplug the unit. Your humidifier is set at the factory to cycle at setting 2. If you find your humidifier is cycling either too often of not often enough, change the Span setting to change the cycle time. 2. Lift the Main Housing as shown in Figure 5. The motor is attached to the main housing. Do not place the motor near water. 1. To see the current Span setting, press both the Humidity and Speed buttons. Grasp here 2. To change the Span setting, Press and hold both the Humidity and Speed buttons for 3 seconds. The LED Display will flash the current Span Setting. 3. Press the Speed button to change the Span setting. Set the Span to 3 to increase the humidifier's run time. Set the Span to 1 to decrease the humidifier's run time. 4. When the LED Display shows your desired Span setting, release the Speed button. After two seconds, the Span is set and the LED Display will show the relative humidity. Figure 5 ©2008 Hunter Fan Co. 4 43002 Rev 04-29