Husqvarna 128L Owners Manual - Page 13
Assembly, itting the trimmer guard and, trimmer head Model 128L, Fitting the loop handle - 128c
View all Husqvarna 128L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ASSEMBLY NOTE: Make sure unit is assembled cor- Fitting the trimmer guard and rectly as shown in this manual. trimmer head (Model 128C) Fitting the loop handle S Position the handle on the shaft. Note that the handle must be mounted be- tween the two arrows on the shaft. S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the wing nut (B). B A S Fit the screw, securing plate and wing nut as shown in the diagram. S Tighten the wing nut. Fitting the trimmer guard and trimmer head (Model 128L) C S Fit the dust cup (C) on the shaft. The nut must be completely covered by the dust cup. S Hold the dust cup with a wrench to prevent the shaft from rotating. S Screw the trimmer head (D) onto the shaft. S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (D). D D B C A A S Fit the drive disc (B) on the output shaft. S Turn the shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. S Insert hex wrench (C) in the hole to lock the shaft. S Screw on the trimmer head (H) in the opposite direction to the direction of rotation. H S To dismantle, follow the instructions in the reverse order. S To dismantle, follow the instructions in the reverse order. 545196750 Rev. 3 2/17/09 English--- 13