Husqvarna 226HD75S Owners Manual - Page 12
Operation
View all Husqvarna 226HD75S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English Operation STARTING ENGINE 1. Feed fuel into the fuel tank and tighten the cap securely. 2. Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start moving upon starting of the engine. 3. Push the primer pump several times until overflown fuel flows out in the clear tube. (1) Primer pump (1) 4. When the engine is cool, move the choke lever to the closed position. (3) (2) (1) Choke lever (2) Close (3) Open (1) 5. Set the ignition switch to the "RUN" position. Release the throttle lever and make sure it is fully back. 6. While holding the unit firmly, pull out the starter rope (2) (3) (1) (1) Ignition switch (2) RUN (3) STOP (4) Throttle lever (4) quickly until engine fires. IMPORTANT • Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures. 7. Move the choke lever to the open position. And pull out the starter rope quickly to restart engine. 8. Allow the engine to warm up for a couple of minutes before starting operation. NOTE 1. When restarting the engine immediately after stopping it, leave the choke open. 2. Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it. STOPPING ENGINE 1. Release the throttle lever and run the engine for a half minute. (2) (3) (1) (1) Ignition switch (2) RUN (3) STOP (4) Throttle lever (4) IMPORTANT 2. Shift the ignition switch to the "STOP" position. NOTE Except for an emergency, avoid stopping the engine while pulling the throttle lever. If the engine won't stop when setting the ignition switch to the stop position, close the choke lever and stop the engine. In this case, please repair the machine at your nearest servicing dealer. RUNNING IN THE ENGINE During the first 20 working hours, do not use the hedgetrimmer at maximum power for long periods. 12