Husqvarna 522L Operation Manual - Page 11

Fitting the loop handle ASSEMBLY Fitting the trimmer guard and trimmer head • Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft. • Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (L). • Slide the spacer into the slot in the loop handle. • Now adjust the trimmer to give a comfortable working position. Tighten the bolt. Fitting the trimmer head WARNING! When fitting the cutting ! attachment it is extremely important that the raised section on the drive disc/ support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. • Fit the drive disc (B) on the output shaft. • Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. • Screw on the trimmer head/plastic blades (H) counter clockwise. H H • To dismantle, follow the instructions in the reverse order. WARNING! Never use a cutting ! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. English - 11