Husqvarna 525RJX Operation Manual - Page 10
Cutting equipment
![]() |
View all Husqvarna 525RJX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
GENERAL SAFETY PRECAUTIONS When fitting, tighten the nut in the opposite direction to the direction of rotation of the cutting attachment. To remove it, undo the nut in the same direction as the cutting attachment rotates. (CAUTION! The nut has a left-hand thread.) When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade. You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut. WARNING! Using an incorrect cutting ! attachment or an incorrectly sharpened blade increases the risk of blade thrust. Cutting equipment Grass blades and grass knifes are intended for cutting coarse grass. A trimmer head is intended for trimming grass. General rules The nylon lining inside the locking nut must not be so worn that you can turn it by hand. The lining should offer a resistance of at least 1.5 Nm. The nut should be replaced after it has been put on approx. 10 times. Cutting equipment This section describes how to choose and maintain your cutting equipment in order to: • Reduce the risk of blade thrust. • Obtain maximum cutting performance. • Extend the life of cutting equipment. IMPORTANT! Only use cutting attachments with the guards we recommend! See the chapter on Technical data. Refer to the instructions for the cutting attachment to check the correct way to load the cord and the correct cord diameter. Keep the teeth of the blade correctly sharpened! Follow our recommendations. Also refer to the instructions on the blade packaging. Only use cutting attachments with the guards we recommend! See the chapter on Technical data. Keep the teeth of the blade correctly sharpened! Follow our instructions and use the recommended file gauge. An incorrectly sharpened or damaged blade increases the risk of accidents. Check the cutting attachment for damage or cracks. A damaged cutting attachment should always be replaced. WARNING! Always stop the engine ! before doing any work on the cutting attachment. This continues to rotate even after the throttle has been released. Ensure that the cutting attachment has stopped completely and disconnect the spark plug cap before you start to work on it. 10 - English 1154813-49 Rev. No 1 2015-06-15
![](/manual_guide/products/husqvarna-525rjx-operation-manual-6ed1ec1/10.png)