Husqvarna 525RJX Operation Manual - Page 12

ASSEMBLY Fitting the loop handle Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft. Fitting the suspension ring Fit the suspension ring between the rear handle and the loop handle. Position the hanging ring so that the machine is balanced and comfortable to work with. Use the harness and attach it to the suspension ring when using grass blades. Assembling the cutting equipment • Slide the spacer into the slot in the loop handle. Fit the nut and screw. Do not overtighten. • Now adjust the trimmer to give a comfortable working position. Tighten the bolt. Fitting the J-handle WARNING! Only grass blades/grass ! cutters or trimmer heads/plastic blades may be used when the J-handle is fitted. Saw blades must never be used with the J-handle. WARNING! ! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. Attach the J-handle to the loop handle using the three screws, as shown. Now carry out fine adjustment to give yourself a comfortable working position. Tighten the screws. WARNING! Never use a cutting ! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. Fitting the trimmer guard and trimmer head • Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination 12 - English 1154813-49 Rev. No 1 2015-06-15