Husqvarna 535LK Owner Manual - Page 13

To prepare the product for start, To start the product, About the surface

Page 13 highlights

• Do the safety inspections, maintenance and servicing that are given in this manual. • Make sure that all covers, trimmer guard and trimmer head correctly attached and not damaged or cracked. Replace if they are exposed to impact or cracked. WARNING: The cutting attachment will start to rotate immediately when you start the engine with the choke. To start the product WARNING: Read the warning instructions in the safety chapter before you start the product (refer to Safety on page 4). 1. Use protective gloves. 2. Hold the body of the product on the ground with your left hand. CAUTION: Do not use your feet! 3. Hold the starter rope handle. 4. Slowly pull out the starter rope with your right hand until you feel some resistance (the starter pawl grip). WARNING: Do not use the product without a guard or a guard that is defective. To prepare the product for start 1. Press the air purge again and again until the fuel starts to fill the bulb. Note: It is not necessary to fully fill the bulb. 2. Move the choke control up into choke position. WARNING: Do not twist the starter rope around your hand. 5. Pull the cord quickly and with power. CAUTION: Do not pull the starter rope all the way out and do not let go off the starter rope handle when the starter rope is fully extended. This can cause damage to the product. 6. Pull the starter rope again and again until the engine starts. 7. Reset the choke when the engine fires. 8. Operate the throttle gradually when the engine starts. 9. Make sure the engine runs smoothly. About the surface WARNING: Do not put parts of your body in the grey marked area. If you touch the grey marked area it can result in burns to the skin. It can also cause electrical shock if the spark plug cap has been damaged. Do not use a product with a damaged spark plug cap. 331 - 008 - 24.04.2020 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80

Do the safety inspections, maintenance and
servicing that are given in this manual.
Make sure that all covers, trimmer guard and
trimmer head correctly attached and not damaged or
cracked. Replace if they are exposed to impact or
cracked.
WARNING:
Do not use the product without a
guard or a guard that is defective.
To prepare the product for start
1.
Press the air purge again and again until the fuel
starts to fill the bulb.
Note:
It is not necessary to fully fill the bulb.
2.
Move the choke control up into choke position.
WARNING:
The cutting attachment will
start to rotate immediately when you
start the engine with the choke.
To start the product
WARNING:
Read the warning instructions in
the safety chapter before you start the
product (refer to
Safety on page 4
).
1.
Use protective gloves.
2.
Hold the body of the product on the ground with your
left hand.
CAUTION:
Do not use your feet!
3.
Hold the starter rope handle.
4.
Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING:
Do not twist the starter rope
around your hand.
5.
Pull the cord quickly and with power.
CAUTION:
Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6.
Pull the starter rope again and again until the engine
starts.
7.
Reset the choke when the engine fires.
8.
Operate the throttle gradually when the engine
starts.
9.
Make sure the engine runs smoothly.
About the surface
WARNING:
Do not put parts of your body in
the grey marked area. If you touch the grey
marked area it can result in burns to the
skin. It can also cause electrical shock if the
spark plug cap has been damaged. Do not
use a product with a damaged spark plug
cap.
331 - 008 - 24.04.2020
13