Husqvarna 555 Workshop Manual - Page 23
Assembling the throttle control, lock, throttle control and spring
View all Husqvarna 555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
6.10 Assembling the throttle control lock, throttle control and spring 1 Lubricate the pin and joined surfaces with a light oil. Hook on the throttle cable (D). Slide in the throttle control and make sure the spring is fitted as outlined in figure 24. NOTE! Make sure that the rear end of the throttle control is correctly aligned inside the cut-out edging before the pin is pressed in place. Fig 24 2 Fit the throttle control's pin (C) using a punch. See figure 25. 3 Fit the throttle control lock (B) by sliding it on the shaft in the handle. See figure 26. Make sure the spring is positioned inside the throttle control lock when you press it down so that the barbs are hooked in place. 4 Fit the handle insert using a screw, when the throttle control, spring, throttle cable and throttle control lock with pin are fitted correctly. Fig 25 Fig 26 Safety equipment C English - 23