Husqvarna CRT900 Owners Manual

Husqvarna CRT900 Manual

Get Husqvarna CRT900 PDF manuals and user guides View all Husqvarna CRT900 manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna CRT900 manual content summary:

  • Husqvarna CRT900 | Owners Manual - Page 1
    CRT900 Owner's Manual 532 43 95-06
  • Husqvarna CRT900 | Owners Manual - Page 2
    , such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure. • Always refer to the operator's guide instructions for important details if the tiller is to be stored for an extended period. - IMPORTANT - CAUTIONS, IMPORTANTS, AND NOTES
  • Husqvarna CRT900 | Owners Manual - Page 3
    your tiller. • Follow instructions under "Maintenance" and "Storage" sections of this Owner's Manual. IMPORTANT: THIS UNIT IS EQUIPPED WITH AN INTERNAL COMBUSTION ENGINE AND MAINTENANCE 11-13 SERVICE & ADJUSTMENTS 14-17 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS-TILLER 20-26 WARRANTY 28-31 3
  • Husqvarna CRT900 | Owners Manual - Page 4
    and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard wrench sizes are listed. (1) Utility knife (1) Tire
  • Husqvarna CRT900 | Owners Manual - Page 5
    TO MOVE Fig. 4 • Rotate handle assembly down. Insert rear carriage bolt first, with bolt head on L.H. side of tiller and loosely assemble locknut (See Fig. 5). • Insert pivot bolt in front part of plate and tighten. • Cut down remaining corners of carton and lay panels flat. • Lower the handle
  • Husqvarna CRT900 | Owners Manual - Page 6
    ASSEMBLY ATTACH CLUTCH CABLE (See Fig. 6) • • Tilt tiller forward by lifting handle. Separate cardboard cover from leveling shield. • Rotate tiller handle to the right and pull tiller out of carton. CHECK TIRE PRESSURE ADJUST HANDLE HEIGHT" in the Service and Adjustments section of this manual). 6
  • Husqvarna CRT900 | Owners Manual - Page 7
    Institute. CHOKE CONTROL - Used when starting a cold engine. DEPTH STAKE - Controls depth at which tiller will dig. DRIVE CONTROL BAR - Used to engage tines. LEVELING SHIELD - Levels tilled soil. RECOIL STARTER HANDLE - Used to start the engine. SHIFT LEVER - Used to shift transmission gears
  • Husqvarna CRT900 | Owners Manual - Page 8
    glasses or eye shields before starting your tiller and while tilling. We recommend a wide vision safety mask for over spectacles or standard safety glasses. 00155 HOW TO USE YOUR TILLER Know how to operate all controls before adding fuel and oil or attempting to start engine. STOPPING (See Fig
  • Husqvarna CRT900 | Owners Manual - Page 9
    SAE 30 summer weight oil. • With engine level, clean area around oil filler plug and remove plug. • Engine oil should be to point of overflowing when engine is level. For approximate capacity see "PRODUCT SPECIFICATIONS" on page 3 of this manual. All oil must meet A.P.I. Service Classification SG-SL
  • Husqvarna CRT900 | Owners Manual - Page 10
    ADJUST CARBURETOR" in the Service and Adjustments section of this manual. NOTE: If engine does not start, see troubleshooting points. SPARK PLUG CHOKE CONTROL RECOIL STARTER engine_art_71 Fig. 13 THROTTLE CONTROL TILLING HINTS CAUTION: Until you are accustomed to handling your tiller, start
  • Husqvarna CRT900 | Owners Manual - Page 11
    MAINTENANCE SCHEDULE MAINTENANCE EEBEEVVEVVFEEEERRORRYYYRYE552S05EEHAAHHOSCOOUHOUURNRRSUSSSE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Engine Oil Level Change Engine Oil Oil Pivot Points Inspect Spark Arrester / Muffler Inspect Air Screen Clean or Replace Air Cleaner
  • Husqvarna CRT900 | Owners Manual - Page 12
    to allow dirt to enter the engine. • Refill engine with oil. See "CHECK ENGINE OIL LEVEL" in the Operation section of this manual. OIL LEVEL OIL FILLER PLUG Fig. 17 AIR CLEANER (See Fig. 18) Service air cleaner cartridge every twenty-five hours, more often if engine is used in very dusty conditions
  • Husqvarna CRT900 | Owners Manual - Page 13
    muffler, air filter and carburetor are covered to keep water out. Water in engine will shorten the useful life of your tiller. • Clean engine, wheels, finish, etc. of all foreign matter. • Keep finished surfaces and wheels free of all gasoline, oil, etc. • Protect painted surfaces with automotive
  • Husqvarna CRT900 | Owners Manual - Page 14
    . Pull wheel out from tiller about 1 inch. • Remove two (2) screws from side of belt guard. • Remove hex nut and washer from bottom of belt guard (located behind wheel). • Pull belt guard out and away from unit. • Replace belt guard by reversing above procedure. BELT GUARD SCREW AND WASHER HEX
  • Husqvarna CRT900 | Owners Manual - Page 15
    section of this manual). • Remove old belt by slipping off engine pulley first then remove from transmission pulley. • Place new belt in groove of transmission pulley and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES. • Check belt adjustment as
  • Husqvarna CRT900 | Owners Manual - Page 16
    maintain the superb tilling performance of this machine the tines should be checked for sharpness, wear, and bending, particularly the tines which are next to the transmission. If the gap between the tines exceeds 3-1/2 inches they should be replaced or straightened as necessary. • New tines should
  • Husqvarna CRT900 | Owners Manual - Page 17
    fuel, temperature, altitude or load. If the carburetor does need adjustment, contact your nearest authorized service center/department IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE
  • Husqvarna CRT900 | Owners Manual - Page 18
    reach an open flame or spark. Allow the engine to cool before storing in any enclosure. TILLER • Clean entire tiller (See "CLEANING" in the Maintenance section of this manual). • Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this
  • Husqvarna CRT900 | Owners Manual - Page 19
    adjustments. 13. Contact an authorized service center/department. Engine overheats 1. Low oil level/dirty oil. 2. Dirty engine air screen. 3. Dirty engine. 4. Partially plugged muffler. 5. Improper carburetor adjustment. 1. Check oil level/change oil. 2. Clean engine air screen. 3. Clean cylinder
  • Husqvarna CRT900 | Owners Manual - Page 20
    PARTS TILLER - - MODEL NUMBER CRT900 (96093001301), PRODUCT NUMBER 960 93 00-13 HANDLE ASSEMBLY                       KEY PART 14 532 10 93-13 Grommet . 5 17 532 10 37 41 (ANDLE?ASSY?? PART NO. DESCRIPTION 532 08 67 Pivot 872 14 04-04
  • Husqvarna CRT900 | Owners Manual - Page 21
    REPAIR PARTS TILLER - - MODEL NUMBER CRT900 (96093001301), PRODUCT NUMBER 960 93 00-13 MAINFRAME, LEFT SIDE                                          KEY PART NO. NO. DESCRIPTION 3 873 22 06-00 Nut,
  • Husqvarna CRT900 | Owners Manual - Page 22
    & Stratton Model No. 121002-1380-B8 (Order parts from Engine Manufacturer) 44 873 51 06-00 Nut, Keps Hex 3/8-16 unc NOTE: All component dimensions given in U.S. inches 1 inch = 25.4 mm For engine service and replacement parts, call the toll free number for your engine manufacturer listed below
  • Husqvarna CRT900 | Owners Manual - Page 23
    REPAIR PARTS TILLER - - MODEL NUMBER CRT900 (96093001301), PRODUCT NUMBER 960 93 00-13 TRANSMISSION 12 9 11 13 15 10 16 60 48 9 14 8 5 7 18 23 6 21 22 5 4 18 19 29 20 31 30 40 18 18 34 43 42 41 25 24 44 3 2 27 18 32 33 28
  • Husqvarna CRT900 | Owners Manual - Page 24
    REPAIR PARTS TILLER - - MODEL NUMBER CRT900 (96093001301), PRODUCT NUMBER 960 93 00-13 TINE SHIELD 34 5 6 7 8 13 29 18 28 23 24 33 25 23 32 5 5 9  5 16 27 26 16 23 24  29 22 21 20 19 14   1 14  TINE?SHIELD??IN?R KEY PART NO. NO. DESCRIPTION 1 873 90 05-00 Nut,
  • Husqvarna CRT900 | Owners Manual - Page 25
    PARTS TILLER - - MODEL NUMBER CRT900 (96093001301), PRODUCT NUMBER 960 93 00-13 TINE ASSEMBLY                TINE?IPB???R KEY PART , Hex 3/8-24 x 1 9 532 00 44-60 Tine, Outer, R.H. KEY PART NO. NO. DESCRIPTION 10 532 13 27-22 Assembly, Hub and Plate, R.H. 11
  • Husqvarna CRT900 | Owners Manual - Page 26
    REPAIR PARTS TILLER - - MODEL NUMBER CRT900 (96093001301), PRODUCT NUMBER 960 93 00-13 DECALS 3 2 1 5 4 7 9 8 10 6 KEY NO. 1 2 3 4 5 6 7 8 9 10 - - - PART NO. DESCRIPTION 532 42 91-96 Decal, Belt Guard Badge 532 43 23-62 Decal, Husqvarna, Control Panel 532 43 14-65 Decal, Control Tine 532 42
  • Husqvarna CRT900 | Owners Manual - Page 27
    SERVICE NOTES 27
  • Husqvarna CRT900 | Owners Manual - Page 28
    (e.g., engines and transmissions) are excluded from coverage, and other limitations apply, as described in this document. Husqvarna will repair or replace at its discretion, any defective product or part covered by the Limited Warranty, free of charge at any authorized Husqvarna Servicing Dealer
  • Husqvarna CRT900 | Owners Manual - Page 29
    date, product model and, if applicable, engine serial number) to an authorized Husqvarna Servicing Dealer for warranty service under this Limited Warranty. Proof of purchase rests solely with the owner-customer. Husqvarna encourages you to register your product online at www.usa.husqvarna.com to
  • Husqvarna CRT900 | Owners Manual - Page 30
    's warranty LCT Engines on specific Snow Throwers & Tillers, warranty through Husqvarna. ** See reference 1 (b) of the warranty statement. RZ - Two (2) Year Consumer warranty, parts & labor, with Hydro-Gear Distributor network. EZ - One (1) Year Commercial warranty, parts & labor, with Husqvarna
  • Husqvarna CRT900 | Owners Manual - Page 31
    's warranty LCT Engines on specific Snow Throwers & Tillers, warranty through Husqvarna. ** See reference 1 (b) of the warranty statement. RZ - Two (2) Year Consumer warranty, parts & labor, with Hydro-Gear Distributor network. EZ - One (1) Year Commercial warranty, parts & labor, with Husqvarna
  • Husqvarna CRT900 | Owners Manual - Page 32
    10.11.10 CL Printed in the U.S.A.
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Owner's Manual
532 43 95-06
CRT900