Husqvarna CRT900 Owners Manual - Page 15
To Replace Ground Drive Belt, See Fig. 23, Ground Drive Belt Adjustment
View all Husqvarna CRT900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
SERVICE AND ADJUSTMENTS TO REPLACE GROUND DRIVE BELT (See Fig. 23) • Remove belt guard (See "TO REMOVE BELT GUARD" in this section of this manual). • Remove old belt by slipping off engine pulley first then remove from transmission pulley. • Place new belt in groove of transmission pulley and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES. • Check belt adjustment as described below. • Replace belt guard. • Reposition wheel and replace clevis pin and hairpin clip. GROUND DRIVE BELT ADJUSTMENT (See Fig. 23) For proper belt tension, the extension spring should have about 5/8 inch stretch when drive control bar is in "ENGAGED" position. This tension can be attained as follows: • Loosen cable clip screw securing the drive control cable. • Slide cable forward for less tension and rearward for more tension until about 5/8 inch stretch is obtained while the drive control bar is engaged. • Tighten cable clip screw securely. ENGINE PULLEY CABLE CLIP SCREW DRIVE CONTROL CABLE IDLER PULLEY TRANSMISSION PULLEY Fig. 23 LESS TENSION EXTENSION SPRING 5/8" MORE TENSION 15