Husqvarna HU700F Owners Manual - Page 13
Maintenance, Service And Adjustments - drive control assembly
View all Husqvarna HU700F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
MAINTENANCE MUFFLER Inspect and replace corroded muffler as it could create a fire hazard and/or damage. SPARK PLUG Replace spark plug at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in the "PRODUCT SPECIFICATIONS" section of this manual. 3. Close mulcher door (if equipped). 4. Connect a garden hose to the fitting where shown. IMPORTANT: BE SURE THE GARDEN HOSE IS NOT ROUTED UNDER THE LAWN MOWER HOUSING OR ENTANGLED IN THE WHEELS. 5. Turn on water supply and check for leaks at the fitting. If no leaks are present, start engine (as described in the Operation section of this manual) and let engine run until the underside of the lawn mower is clean. CLEANING IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN THE UNDERSIDE OF YOUR MOWER AFTER EACH USE. CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. • Clean the underside of your lawn mower by scraping to remove build-up of grass and trash. • Clean engine often to keep trash from accumulating. A clogged engine runs hotter and shortens engine life. • Keep finished surfaces / wheels free of gasoline, oil, etc. • We do not recommend using a garden hose to clean lawn mower unless the electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in shortened engine life. WARNING: Do not engage the drive system during the washout process. 6. Shut off the engine. 7. Shut off water supply and remove hose from fitting. CAUTION: Do not remove hose from fitting while engine is running. Water in engine can result in shortened engine life. 8. Start engine (as described in the Operation section of this manual) and let engine run for a full minute to remove excess water from mower. HOSE CLEAN UNDER DRIVE COVER Clean under drive cover at least twice a season. Scrape underside of cover with putty knife or similar tool to remove any build-up of trash or grass on underside of drive cover. WATER WASHOUT FEATURE (See Fig. 17) Your lawn mower is equipped with a fitting that allows quick and easy cleaning of the underside of the housing. To use this feature, proceed as follows: 1. Move lawn mower to an area of cut grass or another hard surface. NOTE: Water, grass and other debris will drain from beneath the mower housing during the washout process. 2. Remove grass catcher and discharge chute assembly from lawn mower. FITTING FIG. 17 SERVICE AND ADJUSTMENTS CAUTION: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: 1. Release control bar and stop engine. 2. Make sure the blade and all moving parts have completely stopped. 3. Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug. LAWN MOWER REAR DEFLECTOR TO ADJUST CUTTING HEIGHT The rear deflector, attached between the rear wheels of See "TO ADJUST CUTTING HEIGHT" in the Operation section of this manual. your mower, is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator's mowing position. If the deflector becomes 13 damaged, it should be replaced.