Husqvarna T535i XP Owner Manual - Page 12
Operation, Introduction, To do a function check before you use the product
View all Husqvarna T535i XP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Operation Introduction WARNING: Read and understand the safety chapter before you use the product. To do a function check before you use the product 1. Do a check of the chain brake to make sure that it operates correctly and that it is not damaged. 2. Do a check of the power trigger lockout to make sure that it operates correctly and that it is not damaged. 3. Do a check of the keypad to make sure that it operates correctly. 4. Make sure that there is no oil on the handles. 5. Do a check to make sure that all parts are correctly attached and not damaged or missing. 6. Do a check of the chain catcher to make sure that it is attached correctly. 7. Do a check of the chain tension. 8. Charge the battery and make sure that it is correctly attached to the product. 9. Make sure that the saw chain stops when you release the power trigger. WARNING: Use the correct chain oil for this function to operate correctly. Speak to your servicing dealer when you select your chain oil. • Use Husqvarna chain oil for maximum saw chain life and to prevent negative effects on the environment. If Husqvarna chain oil is not available, we recommend you to use a standard chain oil. • Use a chain oil with good adherence to the saw chain. • Use a chain oil with correct viscosity range that agrees with the air temperature. CAUTION: In temperatures below 0°C/ 32°F some chain oils become too thick, which can cause damage to the oil pump components. • Use the recommended cutting equipment. Refer to Accessories on page 27. • Remove the cap to the chain oil tank. • Fill the chain oil tank with chain oil. • Attach the cap carefully. 4 293 1 7 8 56 To use the correct chain oil WARNING: Do not use waste oil, which can cause injury to you and the environment. Waste oil also causes damage to the oil pump, the guide bar and the saw chain. WARNING: The saw chain can break if the lubrication of the cutting equipment is not sufficient. Risk of serious injury or death to the operator. Note: To see where the chain oil tank is on you product, refer to Product overview on page 2. To connect the battery charger 1. Connect the battery charger to the voltage and frequency that is specified on the rating plate. 2. Put the plug in a grounded socket outlet. The LED on the battery charger flashes green one time. Note: The battery does not charge if the battery temperature is more than 50 °C/122 °F. If the temperature is more than 50 °C/122 °F, the battery charger makes the battery become cool before the battery charges. To connect the battery to the battery charger Note: Charge the battery if it is the first time that you use it. A new battery is only 30% charged. 12 959 - 007 -