Husqvarna T540XP Mark III Owner Manual - Page 27
WARNING, To adjust the tension of the saw chain
View all Husqvarna T540XP Mark III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Note: Refer to Filing equipment and filing angles on page 33 for information about which file and gauge that Husqvarna recommends for your saw chain. 2. Apply the file gauge correctly on to the cutter. Refer to the instruction supplied with the file gauge. 3. Move the file from the inner side of the cutting teeth and out. Decrease the pressure on the pull stroke. you to adjust the depth gauge setting after each third operation that you sharpen the cutting teeth. We recommend that you use our depth gauge tool to receive the correct depth gauge setting and bevel for the depth gauge. 4. Remove material from one side of all the cutting teeth. 5. Turn the product around and remove material on the other side. 6. Make sure that all cutting teeth are the same length. General information about how to adjust the depth gauge setting The depth gauge setting (C) decreases when you sharpen the cutting tooth (A). To keep maximum cutting performance you must remove filing material from the depth gauge (B) to receive the recommended depth gauge setting. See Technical data on page 32 for instructions about how to receive the correct depth gauge setting for your saw chain. A C B 1. Use a flat file and a depth gauge tool to adjust the depth gauge setting. Only use Husqvarna depth gauge tool to get the correct depth gauge setting and bevel for the depth gauge. 2. Put the depth gauge tool on the saw chain. Note: See the package of the depth gauge tool for more information about how to use the tool. 3. Use the flat file to remove the part of the depth gauge that extends through the depth gauge tool. To adjust the tension of the saw chain WARNING: A saw chain with an incorrect tension can come loose from the guide bar and cause serious injury or death. A saw chain becomes longer when you use it. Adjust the saw chain regularly. 1. Loosen the bar nuts that hold the clutch cover/chain brake. Use a wrench. WARNING: The risk of kickback increases if the depth gauge setting is too large! To adjust the depth gauge setting Before you adjust the depth gauge setting or sharpen the cutters, refer to Information about the guide bar and saw chain on page 25, for instructions. We recommend Note: Some models have only one bar nut. 2. Tighten the bar nuts by hand as tightly as you can. 3. Lift the front of the guide bar and turn the chain tensioning screw. Use a wrench. 1792 - 005 - 02.11.2022 27