Husqvarna TS 348XD Owner Manual - Page 26
Transmission, Engine
View all Husqvarna TS 348XD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
SERVICE AND ADJUSTMENTS TO REPLACE FUSE (See Fig. 44) Unit has two automotive type fuses. Replace primary operation fuse with a 20 amp and the differential lock actuator fuse with a 10 amp. The fuse holders are located behind the dash. WEAK OR DEAD FULLY CHARGED BATTERY BATTERY Fig. 42 REPLACING BATTERY (See Fig. 43) WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding. • Lift hood to raised position. • Remove terminal cover. • Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor. • Install new battery with terminals in same position as old battery. • Reinstall terminal cover. • First connect RED battery cable to positive (+) battery terminal with bolt and nut as shown. Tighten securely. • Connect BLACK grounding cable to negative (-) battery terminal with remaining bolt and nut. Tighten securely • Close hood. NEGATIVE (BLACK) CABLE Fig. 44 TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 45) • Raise hood. • Unsnap headlight wire connector. • Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. • To replace, reverse above procedure. HOOD HEADLIGHT WIRE CONNECTOR 07002 TERMINAL COVER ENGINE Fig. 45 POSITIVE (RED) CABLE TO ADJUST THROTTLE CONTROL CABLE The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual. Fig. 43 TO REPLACE HEADLIGHT BULB • Raise hood. • Pull bulb holder out of the hole in the backside of the grill. • Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. • Close hood. TO ADJUST CHOKE CONTROL The choke control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual. TRANSMISSION REMOVAL/REPLACEMENT INTERLOCKS AND RELAYS Should your transmission require removal for service or Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting. • Check wiring. replacement, it should be purged after reinstallation and before operating the tractor. See "PURGE TRANSMISSION" in the Operation section of this manual. 26