Husqvarna TS 348XD Owner Manual - Page 6
Assembly
View all Husqvarna TS 348XD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY CONNECT BATTERY (See Fig. 1) WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding. NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in the Maintenance section of this manual for charging instructions.) • Determine battery location. Battery location will be under the seat or the hood. • Lift seat pan or hood to raised position. • Remove two terminal caps and discard. • First connect RED battery cable to positive (+) terminal with bolt and nut as shown. Tighten securely. Slide terminal cover over terminal. • Connect BLACK grounding cable to negative (-) terminal with remaining bolt and nut. Tighten securely. • Lower seat pan or hood. NOTE: For battery installation see "REPLACING BATTERY" in the Service and Adjustments section in this manual. TERMINAL COVER NUT LABEL TERMINAL CAP BOLT POSITIVE (RED) CABLE 02605 NEGATIVE (BLACK) CABLE Fig. 1 INSTALL SEAT (See Fig. 2) Adjust seat before tightening adjustment knob. • Pivot seat upward and remove from the unit. Remove the cardboard and foam packing and discard. • Retrieve the knob, cup washer, three bolts and washers from the bag of parts. • Pivot seat and pan forward and assemble three bolts and washers. Tighten securely. • Assemble adjustment knob and cup washer loosely. Do not tighten. TO ADJUST SEAT • Lower seat into operating position and sit in seat. • Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down. • Get off seat without moving its adjusted position. • Raise seat and tighten adjustment knob securely. SEAT SEAT PAN 6000 WASHER BOLT WASHER BOLT CUP ADJUSTMENT KNOB WASHER BOLT WASHER Fig. 2 VERTICAL SEAT ADJUSTMENT (See Fig. 3) Seat pan comes in the upper position from the factory and can be moved to the lower position for shorter operators. TO ADJUST • Remove nuts and bolts. • Relocate seat pan assembly to lower position. • Reinstall bolts and nuts, tighten to 15-20 ft. lbs. • Refer to "TO ADJUST SEAT" for final seat adjustment. UPPER POSITION BOLT NUTS BOLT LOWER POSITION Fig. 3 6