Husqvarna YT42CS Operation Manual - Page 19
Service And Adjustments
View all Husqvarna YT42CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key to "STOP" and remove key. • Ensure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TO REMOVE MOWER (See Fig. 27) • Place attachment clutch in "DISENGAGED" position. • Lower attachment lift lever to its lowest position. • Remove mower belt from electric clutch pulley (M). • Disconnect front link (E) from mower - remove retainer spring and washer. • Go to either side of mower and disconnect mower suspension arm (A) from chassis and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers. • Go to other side of mower and disconnect the suspension arm and rear lift link. CAUTION: After rear lift links are disconnected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever. • Slide mower out from under right side of tractor. TO INSTALL MOWER (See Figs. 27 - 32) Ensure tractor is on level surface and engage parking brake. • Lower attachment lift lever to its lowest position. CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position. NOTE: Ensure mower side suspension arms (A) are pointing forward before sliding mower under tractor. • Slide mower under tractor until it is centered under tractor. B F M A E C D Fig. 27 19