IBM 4230-4I3 User Guide - Page 230
The Automatic Forms Thickness Adjustment AFTA setting
View all IBM 4230-4I3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 230 highlights
Problem: Forms do not feed past print head 1: The Automatic Forms Thickness Adjustment (AFTA) setting needs to be changed. Solution: See the procedure for adjusting the forms thickness setting through the operator panel (based on your forms device) in Chapter 1, "Setting Up the 4232 Printer Model 302." 2: The forms device is not properly installed. Solution: Check the forms device installation (see Chapter 1, "Setting Up the 4232 Printer Model 302"). 3: The ribbon is twisting or folding. Solution: Replace the ribbon. 4: The forms device is defective. Solution: See "Forms Device Inspection" on page B-24. 5: The ribbon shield is damaged. Solution: Replace the ribbon. B-30 User's Guide Model 302
Problem:
Forms do not feed past print head
1:
The Automatic Forms Thickness Adjustment (AFTA) setting
needs to be changed.
Solution:
See the procedure for adjusting the forms thickness
setting through the operator panel (based on your forms device)
in Chapter
1, “Setting Up the 4232 Printer Model 302.”
2:
The forms device is not properly installed.
Solution:
Check the forms device installation (see Chapter
1,
“Setting Up the 4232 Printer Model 302”).
3:
The ribbon is twisting or folding.
Solution:
Replace the ribbon.
4:
The forms device is defective.
Solution:
See “Forms Device Inspection” on page
B-24.
5:
The ribbon shield is damaged.
Solution:
Replace the ribbon.
B-30
User’s Guide Model 302