IBM 43635gu User Guide - Page 40
is firmly seated in the connector. If there is a gap between the DIMM and
UPC - 883436002950
View all IBM 43635gu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
4. Locate the DIMM connectors on the system board. Determine the connectors into which you will install the DIMMs. Install the DIMMs in the sequence shown in the following table. Number of DIMMs 1 2 (interleaved configuration) 3 4 (interleaved configuration) Installation sequence (connectors) 1 1, 3 Not supported 1, 3, 2, 4 Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently. 5. Open the retaining clips and, if necessary, remove any existing DIMM. 6. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the server. Then, remove the new DIMM from the package. 7. Turn the DIMM so that the DIMM keys align correctly with the slot. 8. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the DIMM connector. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the connector. If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly installed. Open the retaining clips, remove the DIMM, and then reinsert it. If you have other devices to install or remove, do so now; otherwise, go to "Completing the installation" on page 47. 26 System x3200 Types 4362 and 4363: User's Guide