IBM 622020U Maintenance Manual - Page 24
Enabling, Intel, Gigabit, Ethernet, Utility, Using, SCSISelect, program, models, Starting, choices
UPC - 000435052933
View all IBM 622020U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
v If you have forgotten the user password and an administrator password is set, type the administrator password at the power-on prompt. Start the Configuration/Setup Utility program, and change the user password. v Remove the battery, and then install the battery (see "Replacing the battery" on page 29). Enabling the Intel Gigabit Ethernet Utility The Intel Gigabit Ethernet Utility is part of the BIOS code in your computer. You can use it to configure the network as a startable device, and you can customize where the network startup option appears in your startup sequence. Complete the following steps to configure the Intel Gigabit Ethernet Utility program: 1. From the Configuration/Setup Utility main menu, select Advanced Setup, and press Enter. 2. Select Chipset Feature, and use the Right Arrow (→) key to set it to Enabled. 3. Select Save Settings, and press Enter. Using the SCSISelect Utility program (some models) Use the SCSISelect Utility program to configure SCSI devices. Starting the SCSISelect Utility program Complete the following steps to start the SCSISelect utility program: 1. Turn on the computer. 2. When the > prompt appears, press Ctrl+A. If you have set an administrator password, you are prompted to type the password to start the SCSISelect Utility program. 3. When the prompt Would you like to configure the SCSI controller or run the SCSI disk utility? appears, make your selection, and press Enter. 4. Use the arrow keys to select a choice from the menu. 5. Follow the instructions on the screen to change the settings of the selected items, and press Enter. SCSISelect menu choices The following choices appear on the SCSISelect Utility menu: v Configure/View SCSI Controller Settings Select this choice to view or change the SCSI controller settings. To reset the SCSI controller to its default values, press F6; then, follow the instructions that appear on the screen. You can view or change the following controller settings: - SCSI Controller ID Select this choice to view the SCSI controller ID, which is typically 7. - SCSI Controller Termination This choice is set to Enabled and cannot be changed. 14 IBM IntelliStation M Pro Types 6220 and 6230: Hardware Maintenance Manual