IBM 8687 Installation Guide - Page 140
Adding support for the RXE-100, Before you begin
UPC - 087944724261
View all IBM 8687 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Figure 4-13 Shows that hot-plug is enabled Tip: You can debug the driver by powering down the machine, rebooting, and entering: LOAD C:\IBMXSBD.NLM -DBGALL > C:\IBMXSBD.TXT Adding support for the RXE-100 To add support for RXE-100, a new NBI.NLM file must be obtained by going to http://support.novell.com/filefinder/ and searching for NBIUP1.EXE. This file contains a new NetWare Bus Interface driver, NBI.NLM. The new driver adds support for the x440 when the RXE-100 is installed. Before you begin: Attach the RXE-100 (do this after the NetWare installation). The NetWare Support Pack must be installed before installing the new NBI.NLM. Otherwise, installing the support pack will overwrite the new NBI.NLM Perform the following operation: 1. Bring the server down to a DOS prompt. 2. Go to C:\NWSERVER directory and rename the NBI.NLM to NBI.OLD if it exists. 126 IBM ^ xSeries 440 Planning and Installation Guide