IBM 88704RX User Manual - Page 55
Cable, Remote, Supervisor, Adapter, II-EXA
![]() |
UPC - 087944856542
View all IBM 88704RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Cable the Remote Supervisor Adapter II-EXA: This section provides the information needed to cable the Remote Supervisor Adapter II. 1. Connect the RSA II-EXA breakout cable to the RSA II-EXA breakout port on the server. Figure 16. Connect the RSA II-EXA breakout cable to the server 2. Connect the video cable from your video device to the video port on the Remote Supervisor Adapter II-EXA. 3. Plug the USB connector on the RSA II-EXA breakout cable into one of the USB ports on the rear of the server. ASM RS-485 connector USB connector Management connectors Figure 17. RSA II-EXA breakout cable 4. Complete the following steps to connect the Remote Supervisor Adapter II-EXA to the LAN: a. Connect one end of a Category 3 or Category 5 Ethernet cable to the Ethernet connector on the Remote Supervisor Adapter II-EXA. Connect the other end of the Ethernet cable to your network. Chapter 2. Configuring the server 43
![](/manual_guide/products/ibm-88701rx-user-manual-c470847/55.png)