IBM 88728AU Installation Guide - Page 33
Completing, installation, Connecting, cables
![]() |
UPC - 000435957627
View all IBM 88728AU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
6. Connect any required cables to the adapter. 7. Connect the power cables and any previously removed external cables to the server. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation." Completing the installation Wire cable clip (open) Wire cable clip (closed) To complete the installation, complete the following steps: 1. Make sure all internal cables are properly routed and are held in place by the wire cable clip in the center of the server. 2. Install the top cover. 3. Install the server in a rack. See the Rack Installation Instructions that come with the server for complete rack installation and removal instructions. 4. Connect the cables and power cords. See "Connecting the cables" for more information. Connecting the cables You must turn off the server (see "Turning off the server" on page 35) before connecting any cables to or disconnecting any cables from the server. See the documentation that comes with optional devices for additional cabling instructions. It might be easier for you to route cables before you install certain options. Cable identifiers are printed on the cables that come with the server and options. Use these identifiers to connect the cables to the correct connectors. For details about the location and function of the input and output connectors, see Chapter 3, "Server controls, connectors, LEDs, and power," on page 31. Chapter 2. Installing options 21
![](/manual_guide/products/ibm-88728au-installation-guide-aa7e7d4/33.png)