IBM A40p Hardware Maintenance Manual - Page 52
External parallel device, If a component is called out, make sure
View all IBM A40p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Diagnostic Error Code 014-001-XXX Parallel port Presence 014-002-XXX 014-003-XXX Parallel port Timeout/Parity error 014-013-XXX 014-014-XXX Parallel port Control Signal/Loopback test failure 014-015-XXX Parallel port External Loopback failure 014-027-XXX Parallel port Configuration/Setup error 014-03X-XXX 014-04X-XXX Parallel port failure 014-195-XXX Parallel port Test aborted by user 014-196-XXX Parallel port test halt, error threshold exceeded 014-197-XXX Parallel port test warning 014-198-XXX Parallel port test aborted 014-199-XXX Parallel port test failed, cause unknown 014-2XX-XXX 014-3XX-XXX Parallel port failure 015-000-XXX USB port Interface Test Passed 015-001-XXX USB port Presence FRU/Action 1. Remove external parallel device, if present 2. Run setup, enable port 3. System board 1. System board 1. System board 1. Wrap plug 2. System board 1. Run Setup, enable port 2. Flash the system 3. System board 1. System board 1. Information 2. Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled 2. Re-run test 3. Component that is called out in warning statement 4. Component under test 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test 3. Go to the ″Undetermined problems″ section 1. Go to the ″Undetermined problems″ section 2. Flash the system and re-test 3. Replace component under function test 1. External parallel device 2. System board 1. No action 1. Remove USB device(s) and re-test 2. System board 46 Hardware Maintenance Manual A40 Type 6840 A40P Type 6841 A40i Type 2271: IBM NetVista Computer