Icom F9011 / F9021 Instruction Manual - Page 17
BASIC OPERATION, ■ Turning power ON, ■ Channel selection
View all Icom F9011 / F9021 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3 BASIC OPERATION ■ Turning power ON ■ Channel selection 1 • Prior to using the transceiver for the first time, the battery Several types of channel selections are available. Methods 2 pack must be fully charged for optimum life and opera- may differ according to your system set up. 3 tion. (p. 17) • When you use the transceiver for the first time, or after NON-ZONE TYPE: 4 the transceiver has sat unused for a long time, make To select the desired operating channel: 5 sure to check the date and time indication after turning • Push [CH Up] or [CH Down]. the power ON. If the time and date are not correct, reset • Rotate [ROTARY SELECTOR]*. 6 them. (p. 15) q Rotate [VOL] to turn the power ON. - Up to pre-programmed 16 channels can be selected. 7 • Push one of [MR-CH 1] to [MR-CH 4]. 8 w If the transceiver is programmed for a start up password, input the digit codes as directed by your dealer. ZONE TYPE: To select the desired zone: 9 • 10-keypad* can be used for password input. • Push [Zone], then push [CH Up] or [CH Down]. 10 * IC-F9011T only • The keys in the table below can be used for password input. • Rotate [ROTARY SELECTOR]*. - Up to pre-programmed 16 zones can be selected. 11 • The transceiver detects numbers in the same block as identical. Therefore "01234" and "56789" are the same. AUTOMATIC SCAN TYPE: 12 KEY Channel setting is not necessary for this type. When turn- 13 NUMBER 0 1 2 3 4 5 6 7 8 9 ing power ON, the transceiver automatically starts scanning. 14 Scanning stops when receiving a call. 15 e When the "PASSWORD" indication does not clear after in- * Depending on the pre-setting. When [Rotary selector] selects "Operating channel," [CH Up]/[CH 16 putting 6 digits, the input code number may be incorrect. Turn the power off and start over in this case. Down] are not available. When [Rotary selector] selects "Operating zone," [Zone]/[Zone Up]/ [Zone Down] are not available. 12