Icom IC-F2000 Operating Guide - Page 11
Tx Code Ch Up/dn
View all Icom IC-F2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
PANEL DESCRIPTION 1 SURVEILLANCE < for the Non-display type transceivers > TX CODE CH SELECT 1 // only for the Simple type and 10-key type transceivers // ➥➥Hold down to turn ON the Surveillance function. ➥➥Push [TX Code CH Select] to enter the TX code channel ➥➥Push to turn OFF the function. selection mode. < for the Simple type and 10-key type transceivers > 1. Push [CH Up] or [CH Down] to select a desired TX ➥➥Push to turn the Surveillance function ON or OFF. code channel. • When this function is ON and a signal is received, a 2. After selecting, push [TX Code CH Select] to store the beep does not sound and the LED does not light, even if setting and return to the standby mode. you push any key. // only for the PMR model // SIREN ➥➥During TX code selection mode, hold down to enter the TX ➥➥Hold down to emit a siren sound. code edit mode (5-Tone). • This function may use for situations other than an emer- 1. Push [CH Up] or [CH Down] to select the desired digit. gency alert, such as a security alarm. You can also enter the digit using the 10-key pad if it is ➥➥Turning OFF the transceiver power to stop the siren on your transceiver. sound. 2. Push [TX Code Enter] to set. The digit to the right will automatically blink. TX CODE ENTER 3. Repeat step 1 and step 2 to input all editable digits. // only for the PMR model (for the Simple type and 4. After editing, push [TX Code Enter] to store the set- 10-key type transceivers) // tings and return to the standby mode. ➥➥Push to enter the TX code edit mode (5-Tone). 1. Push [CH Up] or [CH Down] to select the desired digit. TX CODE CH UP/DN You can also enter the digit using the 10-key pad, if it is // only for the LMR model (for the Simple type and on your transceiver. 10-key type transceivers) // 2. Push [TX Code Enter] to set. The digit to the right will ➥➥Push to select a preprogrammed TX code channel. automatically blink. 3. Repeat step 1 and step 2 to input all editable digits. 4. After editing, push [TX Code Enter] to store the setting and return to the standby mode. 8