Icom M220 Instruction Manual - Page 41
Receiving a Position Request call, When a Position Request call is received
![]() |
View all Icom M220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
7 DIGITAL SELECTIVE CALLING (DSC) DDReceiving a Position Request call (May not be used, depending on the presetting) 1 NOTE: Even if the Auto ACK function is set to "Manual," after receiving a Distress Acknowledgement, or while in the Distress Cancel call procedure, the Position Reply is 2 automatically sent to the calling station. 3 When a Position Request call is received: ••An alarm sounds. 4 ••"RCVD POS Request" is displayed. 5 1. Push ALARM OFF to turn OFF the alarm. 6 2. Push the Software Key below the intended operation. 7 IGN : Ignores the call and returns to the 8 (Ignore) operating screen. ••The call is saved in the DSC Log. 9 ••" " blinks continuously until you display the call message. 10 ABLE : Sends Acknowledgement "Able to (Able to comply" right away. 11 comply) Sends an Acknowledgement "Unable to 12 UNABLE : (Unable to Comply) Comply." ••The call is saved in the DSC Log. ••Displays the Acknowledgement information, and then returns to the 13 14 ACPT : operating screen by pushing EXIT . Accepts the call. 15 (Accept) ••Displays the received call's information. ••The call is saved in the DSC Log. 16 Push ABLE or UNABLE , then push CALL to send the Position Reply call. (p. 27) 17 18 31
![](/manual_guide/products/icom-m220-instruction-manual-5c5672f/41.png)