Icom VE-PG4 Instruction Manual - Page 2

REPLACING THE CONNECTOR If the cable becomes damaged, replace the connector(s). Make wire connections as described below. • Spare connectors*1 are supplied with the VE-PG3 or VE-PG4. • If reconnecting is repeated about 30 times, replace the connector. *1 Manufacturer: DDK. Name: 232D-04S1B-DA5-FA The connector has two parts: a black base and a clear insert. DO NOT lock the connector parts before inserting all wires. 1 Cut the wires*2 *3 2 near the connector. *2 Remove the cable from the VE-PG3 1234 or VE-PG4, before cutting the wires. *3 DO NOT cut the wires too short. Oth- erwise it will be difficult to reconnect them to the VE-PG3 or VE-PG4. Insert the wires into the holes according to the assigned pin numbers. Connector (Supplied with the VE-PG3 or VE-PG4) 3 Press the clear insert down until it locks in place. • After the insert is locked, it is impossible to release it again. The wires for each hole are assigned by color. See the illustration below. V OPC-2390 wires assignment ABC Connector top (Expanded view) A B C OPC-2390 Pin No. 1 2 3 4 1234 Orange Blue Gray White Yellow 1 234 Red Green Black Pink DISPOSAL The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that in the European Union, all electrical and electronic products, batteries, and accumulators (rechargeable batteries) must be taken to designated collection locations at the end of their working life. Do not dispose of these products as unsorted municipal waste. Dispose of them according to the laws in your area. Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries. 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan A7488X-1EX Printed in Japan © 2018 Icom Inc.