Image Fitness 20.0 Vt Treadmill English Manual - Page 12

12. See the lower drawing. Position the Uprights (53, 54) so that the Frame (51) is centered be- 12 tween them. Firmly tighten the two M10 x 60mm Patch Bolts (1) and the four M10 x 58mm Bolts (2) (only one side is shown). Be careful not to overtighten the M10 x 60mm Patch Bolts. Raise the Uprights (53, 54). 53, 54 1 2 51 Top View 54 51 53 13. Attach the Latch Housing (48) to the Left Upright (53) with two #10 x 1" Tek Screws (13); start both Tek Screws, and then tighten each of them. Make sure that the large hole in the Latch Housing is on the indicated side. Locate the Latch Pin Assembly (24). Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Insert the pin into the Latch Housing (48). Then, tighten the knob onto the pin. 13 Knob 24 48 13 Large Hole 53 Spring Collar Pin 14. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. One of the hex keys is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill. 12