Image Fitness 5.5 Bench English Manual - Page 7
Joint Plates 6 to the Left Base 3 using four M10
View all Image Fitness 5.5 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Tap a 60mm Square Inner Cap (28) into the top of each of the Front Uprights (7). 3 Attach one of the Front Uprights (7) and two Rack Joint Plates (6) to the Left Base (3) using four M10 x 78mm Bolts (31) and four M10 Nylon Locknuts (29). Make sure the Front Upright is oriented so that the holes on the bottom of the Front Upright and the holes in the Joint Plates line up. If they do not line up, turn the Front Upright upside-down. Do not tighten the Nylon Locknuts yet. Make sure the Front Upright is turned so the adjustment holes are facing the Rear Upright (8). 1 31 Attach the other Front Upright (7, not shown) and two Rack Joint Plates (6, not shown) to the Right Base (1) in the same manner. 6 28 8 7 Adjustment Holes 29 3 6 29 4. This step will require two people. 4a Refer to drawing 4a. Have one person hold out the Adjustment Knobs (22) on a Safety Spotter (20), while the other person slides the Safety Spotter 19 down over the right Uprights (7, 8), as shown. Hold the Adjustment Knob out on the Weight Rest (19), and slide the Weight Rest onto the Front Upright (7). To avoid breaking the Square Bushings (21) inside the top and bottom of the Safety Spotter 20 and Weight Rest, be careful not to catch the Square Bushings on the edges of the Uprights as they slide on. Refer to drawing 4b. Secure the Safety Spotter (20) and the Weight Rest (19) to the right Uprights (7, 8) by snapping the three Adjustment Knobs (22) into adjustment holes in the Uprights and turning them clockwise until tight. Assemble the other Safety Spotter (20) and Weight Rest (19) to the left Uprights (7, 8) in the same 5 manner. Make sure both Safety Spotters and both Weight Rests are at the same height. 29 5. Attach the Chin-up Bar (13) and two Rack Joint Plates (6) to the Front Uprights (7) using four M10 x 78mm Bolts (31) and four M10 Nylon Locknuts (29). Do not tighten the Nylon Locknuts yet. 4b 21 7 8 21 19 22 22 21 20 22 8 7 6 13 31 6 31 7 7 29 7