Image Fitness 5.5 English Manual - Page 11
Note: Tighten all the M10 Nylon Locknuts 29
View all Image Fitness 5.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
17. Press a 51mm x 76mm Outer Cap (56) onto each end of the Stabilizer (58). 17 Attach the Stabilizer (58) to the Bench Frame (52) with two M10 x 58mm Carriage Bolts (57) and two M10 Nylon Locknuts (29). Attach the Stabilizer so that the warning decal is in the position shown. Note: Do not tighten the Nylon Locknuts yet. 56 52 58 29 Decal 18. Press a 50mm Square Outer Cap (65) onto each end of the Bench Base (53). Attach the Bench Base Joint Plate (64) to the Bench Base (53) with two M10 x 68.5mm Bolts (75), two M10 Washers (37), and two M10 Nylon Locknuts (29). Attach the Bench Leg (48) to the Bench Base Joint Plate (64) with two M10 x 68.5mm Bolt (75), two M10 Washers (37), and two M10 Nylon Locknuts (29). Be sure the welded nut is in the position shown. Note: Do not tighten the Nylon Locknuts yet. 57 56 18 Welded Nut 48 37 75 53 37 29 65 37 64 75 37 65 19. Attach the Bench Leg (48) to the Bench Frame (52) with two Bench Joint Plates (63), four M10 x 72mm Bolts (34), and four M10 Nylon Locknuts (29). Note: Tighten all the M10 Nylon Locknuts (29) used in steps 17-19. 19 34 63 52 63 48 29 20. Press two 25mm x 38mm Inner Caps (72) into each Backrest Tube (71). Press two 25mm x 38mm Inner Caps into the Backrest Adjustment Bracket (79). Lubricate a M10 x 192mm Bolt (66). Attach the Backrest Tubes (71) to the welded tube on the Backrest Adjustment Bracket (79) with the Bolt, two M10 Washers (37) and a M10 Nylon Locknut (29). Make sure that the Backrest Tubes are turned as shown. The indicated holes are closer to one side. Turn the Backrest Tubes so the holes are closer to the floor. Do not over tighten the Nylon Locknut; the Backrest Tubes must pivot easily. 20 Lubricate 71 37 66 Holes 72 37 29 72 Welded Tube 79 72 11