Image Fitness Executive 2002 English Manual - Page 6
Assembly
View all Image Fitness Executive 2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area. Do not remove the packing material from the area shown in drawing 2. Remove all other packing materials. Do not dispose of the packing materials until assembly is completed. Treadmill assembly requires the included allen wrench your own phillips screw- driver and 9/16" wrench . Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. 1. See drawing 2. Leave in place the packing material shown in the indicated area until step 1 is completed. While a second person holds one end of the treadmill, carefully tip the treadmill onto its side as shown. Using the included allen wrench and a 9/16" wrench, attach the two Extension Legs (70) to the base of the Uprights (109) with the four Bolts (71) and Nuts (68). Make sure that the Extension Legs are turned so the Base Pads (66) are in the positions shown. With the help of a second person, carefully raise the treadmill to the vertical position, and then lower the Walking Platform (93) to the floor. Note: If the treadmill rocks slightly, tip the treadmill back onto its side, loosen the four Nuts (68), adjust the positions of the Extension Legs (70), and then retighten the Nuts. Raise the treadmill back to the vertical position. Repeat until the rocking motion is eliminated. 2. Remove the packing material from the area shown. Attach the Storage Latch Assembly (33) and the Latch Spacer (35) to the left Upright (109) with two Latch Screws (34) as shown. Be careful not to overtighten the Latch Screws. 1 93 109 2 Felt 68 66 70 71 68 66 70 71 Packing Material Thread the Console Latch (55) into the right Upright (109). 35 34 33 109 3. Pull the Console Latch (55) to the right, and rotate the 3 Console Base (43) to the position shown. Release the Console Latch, making sure that the Console Base is locked in place. Note: It may be helpful to push down on the right Handrail (39) and push the Console Latch into the locked position. Note: If the Handrail (39) rocks, attach one or two pieces of the included felt onto the bracket in the locations shown in drawing 2. 6 55 Felt 109 43 39 55