Image Fitness Renew 739 Spa English Manual - Page 13

Maintenance The hydrotherapy spa is designed to provide years of enjoyment. Please follow the guidelines below to properly maintain your spa. MAINTENANCE SCHEDULE Daily • Check the water level and refill the spa to the level shown in step 5 on page 9. • Check the pH balance and sanitizer level. Adjust them if necessary (see WATER CHEMISTRY). Weekly • Clean the spa shell at the waterline. • Check and thoroughly clean the filters (see CHECKING AND CLEANING THE FILTERS. • Replace the filters if needed (see ORDERING REPLACEMENT PARTS on the back cover). Monthly • Clean the spa cover (see MAINTAINING THE SPA COVER). • Soak the filters for two hours in a trisodium phos- phate (TSP) solution. Rinse the filters in clean water. • Replace the filters if needed (see ORDERING REPLACEMENT PARTS on the back cover). Every Three Months • Drain the spa and refill it with clean water. Sanitize and test the pH of the water. • Check for any leaks around the pump or joints in the pipes. The seals will wear out over time; detecting leaks early can reduce repair costs. • Clean the interior of the spa. Do not use solvents or waxes. MAINTAINING THE SPA EXTERIOR The premium cedar surround has been treated at the factory. For information and supplies to maintain the beauty and color of your premium cedar surround, contact your local pool and spa supply store. CLEANING THE SPA SHELL The spa shell should be cleaned with a mild soap solution; do not use solvents or waxes. The spa should always be clean and dry before being moved or stored. MAINTAINING THE SPA COVER Clean the spa cover monthly. To clean the spa cover, use water and a non-abrasive cleaner on the entire cover. Rinse the cover with a garden hose to remove any cleaner residue. Dry the cover entirely. Use a non-silicone-based vinyl conditioner on the cover after you clean it. This will help protect the cover from sun damage. CHECKING AND CLEANING THE FILTERS The filters should be checked periodically for build-up of dirt and oil. If the filters need to be cleaned, follow the steps below: 1. Turn off the power. 2. Unscrew the filter covers. 4. Lift the the filters out of Filter Cover the filter housings. 5. Check the filters for dirt and debris. If the filters Filter need to be cleaned, rinse the filters with a hose. If the filters are Filter Housing still dirty, soak it in cleaning solution from a pool and spa supply store. 6. Inspect the filters for damage. Replace the filters if the are damaged. 7. Insert the cleaned or new filters into the filter hous- ings. 8. Re-attach the filter covers. WATER CHEMISTRY The maintenance of the pH level is very important to the operation of the spa. To maintain the proper pH level and to sanitize the spa, you can purchase a chemical starter kit from your local pool and spa supply store. CAUTION: The chemicals used to maintain the pH balance of the water and to sanitize the water can be dangerous. Always follow these basic guidelines when handling the chemicals: 1. Always read and follow the directions on the label, unless directed otherwise. 2. Never mix different chemicals. 3. Do not exceed the recommended amounts of chemicals-follow the directions on the label closely. 4. Keep all chemicals out of the reach of children and pets. 5. Keep containers closed tightly when not in use. 6. Never add water to the chemicals-always add the chemicals to the water as directed. 7. Always store chemicals in a cool, dry place. 13