Image Fitness Renew 739 Spa English Manual - Page 9

3. Insert the pillow (47) into the lounge seat receptacle. The pillow can be rotated 180º to change between the high or low positions. 3 47 4. The hydrotherapy spa operates on a 240-volt power source and must be wired directly to a 40 amp Ground Fault Circuit Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified, licensed electrician. A wiring diagram is found on the inside of the electronics package for reference. Under no circumstances should the spa be wired by someone other than a qualified electrician. Before you have the spa wired, make sure it is in the desired position, and that it can be easily serviced, if needed. 5. Make sure that a qualified electrician has wired the 5 spa to a 240-volt power source. Remove the two warning decals (see page 5) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service it. Once the spa is filled, it will have to be drained before it can be moved. 3 Fill to Here 5 Using a garden hose or other clean water source, begin filling the spa. Place the hose into the filter housing. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the level shown at the right. Do not overfill the spa. Garden Hose Refer to the inset drawing. Set the Filters (5) into the filter housings. Next, screw the Filter Covers (3) into the filter housings until they are fully seated. 6. Pull down one of the straps on the Spa Cover (11) and hold the Buckle (26) against one of the premium 6 cedar panels on the spa. (Note: To position the 11 Buckle correctly, have a second person hold the strap on the opposite side of the Spa Cover snug.) The Spa Cover must be snug. Do not place the Buckle over the grooves between the premium cedar panels. Refer to the inset drawing. Remove the latch from the Buckle (26). Attach the Buckle to the premium cedar panel with two #4 x 3/4" Screws (27). Attach the other three Buckles (26) to the premium cedar panels in the same way. Remove the Spa Cover (11) from the spa. Strap Latch 26 27 Strap 26 9