Insignia IN-CS102 User Manual (English) - Page 9
Switching On/off The Unit
View all Insignia IN-CS102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
OPERATION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button (except button (7) and button (4)). When system is on, press PWR button (9) to turn off the unit. FACEPLATE RELEASE Press button (7) to detach the removable faceplate. SOUND ADJUSTMENT Press SEL button (10) shortly to select the desired adjustment mode. The adjustment mode will change in the following order: VOL BAS TRE BAL FAD (Volume) (Bass) (Treble) (Balance) (Fader) By rotating the VOLUME knob (11) clockwise or counterclockwise, it is possible to adjust the desired sound quality. Press and hold the SEL button (10) for several seconds to enter into the selection for the situation of beep sound, then rotate the VOLUME knob (11) clockwise or counter-clockwise to select as follows: BEEP 2ND BEEP ALL BEEP OFF - BEEP 2'nd mode: The beep is only generated when all allowed double function button is pressed long (several seconds). e.g. When preset button is pressed. When BND/LOU button (13) is pressed. When AS/PS button (18) is pressed. - BEEP ALL mode: The beep is generated when every key is pressed. - BEEP OFF mode: The beep is disabled. LOUDNESS Press BND/LOU button (13) for several seconds to reinforce the bass output. Press it for several seconds again to release this function. SET THE CLOCK Press the DSP button (15), the clock is shown on the LCD display. Then hold down the button until the clock flashes. Then press the MANU/SKIP button (17) to change hours or MANU/SKIP button (16) to change minutes. MUTE Press MUT button (3) to mute down the sound instantly. If any button is pressed in the mute state, the mute state is released. EQUALIZATION Press EQ button (19) to turn on equalization function and to select desired audio mode. There are five kinds of mode as below: FLAT CLASSICS POP M ROCK M DSP OFF LIQUID CRYSTAL DISPLAY Exhibit current frequency and activated functions on the display (8). FLASHING LED If the front panel does not install in the main unit, the LED (12) will be flashing. RESET FUNCTION RESET button (24) must be activated with either a ballpoint pen or thin metal object and it should be pressed for more than one second. The RESET button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. - All the function buttons do not operate. - Error symbol on the display. Note: If press RESET button (24), the unit can't work yet, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the front panel. 9