Insignia IS-CM100751 User Manual (English) - Page 6
To remove the tilt/swivel stand, To connect the video cable and power cord
![]() |
View all Insignia IS-CM100751 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
IS-CM100751_combined.fm Page 4 Tuesday, April 12, 2005 10:14 AM IS-CM100751 19-inch Color Monitor 4 Insert the hooks into the guide holes. 5 Slide the tilt/swivel stand toward the front of the monitor until the latch snaps into place. 6 Turn the monitor and the stand upright. To remove the tilt/swivel stand: 1 Make sure that the power is turned off to the monitor. 2 Set the monitor face down with the underside facing you. Be careful not to scratch the monitor screen. 3 Press the latch, then pull the tilt/swivel stand toward the back of the monitor. 4 Pull the stand away from the monitor. To connect the video cable and power cord: 1 Turn off your computer and monitor. 2 Connect the VGA cable to your computer's VGA port. 3 Tighten the VGA connector's thumbscrews to secure it to your computer. 4 Plug the power cord into the AC receptacle located on the back of your monitor. 5 Plug the other end of the power cord into an AC outlet. VGA cable Power cord 4 www.Insignia-Products.com
![](/manual_guide/products/insignia-iscm100751-user-manual-english-3e1e428/6.png)