Insignia NS-A1111 User Manual (English) - Page 12
Troubleshooting, Specifications, Warranty information
View all Insignia NS-A1111 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
NS-A1111_final_translationDTP.fm Page 12 Friday, February 17, 2006 12:09 PM Cleaning CDs A dirty disc causes sound skipping, and if the disc is very dirty, the CD may not work at all. Handle the disc by holding its inner and outer edges. • Fingerprints and dust should be carefully wiped from the surface of the CD with a soft cloth. Wipe in a straight motion from the center to the edge. • Never use thinner, benzine, record cleaner, or anti-static spray on a CD, because they can damage its plastic surface. Note Before transporting the unit, remove any disc from the disc compartment. Troubleshooting Problem Solution No sound. No or unbalanced sound from a speaker. • Turn the volume knob up. • The headphones are connected. Disconnect them. • Reset the unit by pressing the ON/OFF button. Check the speaker connections of the inoperative speaker. Reversed left and right sound. Check the speaker cord connection and speaker location. Severe hum or noise. • A TV or VCR is too close to the shelf system. Separate the shelf system from the TV or VCR. • The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol. • Clean the disc. • Adjust the antenna wire. The FM stereo indicator flashes. Reception is poor. Adjust the antenna wire. CD door does not close due to power off or other functions are selected without first closing the door • Press the ON/OFF button to turn on the shelf system. • Press the Function button to select CD mode. • Press the Open/Close button to close the CD door. The disc does not play • The disc is not inserted correctly or is upside down. Insert the disc correctly. • Clean the disc. • The CD system is in the pause mode. Press the Play button to leave pause mode. Distorted playback or sound loss during CD playback • Condensation may have formed inside the unit because of a sudden change in temperature. Wait about an hour for the condensation to evaporate and try again. • CD disc is dirty or scratched. Clean the disc. Insignia NS-A1111 5-CD Shelf System Specifications Design and specifications are subject to change without notice. Power sources Power supply Remote control batteries Power consumption 120 V AC 60 Hz 3 V (1) 15 W FCC compliance This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. Safety certification This shelf system is made and tested to meet safety standards of the FCC, requirements and compliance with safety performance of the U.S. Department of Health and Human Services, and also with FDA Radiation Performance Standards 21 CFR Subchapter J. Warranty information Limited warranty Insignia Products warrants to you, the original purchaser of this Product, that this product shall be free of defects in material or workmanship for a period of ninety (90) days from the date of purchase as follows: 1 LABOR: During the Warranty Period if this Product is determined to be defective, Insignia will repair or replace the Product, at its option at no charge, or pay the labor charges to any Insignia authorized service facility. After the Warranty Period, you must pay for all labor charges. 12 www.insignia-products.com