Insignia NS-BC48SS3 User Guide - Page 13

48-Can Beverage Cooler Troubleshooting CAUTION: Do not try to repair your beverage cooler yourself. Doing so invalidates the warranty. Fault indication If a fault is detected, the display shows one of the following codes: Fault code E1 E6 Description Temperature sensor fault Communication fault Note: When the above faults are displayed, do not attempt to repair your cooler by yourself. Please contact customer service for help. PROBLEM My beverage cooler does not operate. The cooler door does not close completely. POSSIBLE CAUSE POSSIBLE SOLUTION Your beverage cooler is Make sure that your beverage cooler is plugged unplugged. in and that the plug is pushed completely into the outlet. The fuse on the circuit Check the house fuse/circuit breaker box and is blown or the circuit replace the fuse or reset the circuit breaker. breaker is tripped. Power failure. If a power failure occurs, your beverage cooler turns off. Wait until the power is restored, then turn it on again. Your power source has Make sure that your power source has the the incorrect voltage. correct voltage (115V). The shelf is out of position. Adjust the shelf correctly. The door gaskets are Clean the door gaskets. dirty. Your cooler is not level. Level your cooler with the leveling feet. The door gasket does not seal. • Make sure that the door gasket is clean. • Try heating then cooling the seal. You can use an electric hair dryer to heat the seal. www.insigniaproducts.com 13