Insignia NS-CADVD User Manual (English) - Page 7

Insignia NS-CADVD DVD Player Connecting a TV with S-Video To connect a TV with S-Video: 1 Connect an S-Video cable to the S-Video Out jack on the back of your TV and to the S-Video In jack on the TV. Back of player CVBS VIDEO OUT OPTICAL OUT PUT S-Video cable Audio cable TV 2 Connect an audio cable to the MIX L/R jacks on the back of your player and to the AV AUDIO IN jacks on the TV. 3 Turn on your player. The default TV video type is set to S-Video. If you have changed the TV video type, press PSCAN/NORMAL to select S-VIDEO. 4 Turn on the TV, then select the appropriate input source. For more information, see the documentation that came with the TV. Connecting a TV with component video To connect a TV with component video: 1 Connect a component video cable to the YPbPr jacks on the back of your player and to the Component In jacks on the TV. Back of player Component video cable CVBS VIDEO OUT OPTICAL OUT PUT Using your player Turning your player on or off Warning When your player is in standby mode, it is still receiving power. To completely disconnect power, unplug the power cord. To turn your player on or off: 1 Press Power. Your player turns on. 2 Press Power again to turn off your player. Using the remote control • Point the remote control toward the remote control sensor on the front of your player. • Make sure that no objects are between the remote control and the remote control sensor. • Do not expose the remote control to shock. • Do not expose the remote control to liquids or high humidity. • Do not place your player in a location where sunlight or bright light shines on the remote control sensor. This can interfere with the signal from the remote control. The following illustration shows the best angle for using the remote control. 19.7ft. (6 m) 30° 30° Audio cable TV 2 Connect an audio cable to the MIX L/R jacks on the back of your player and to the AV AUDIO IN jacks on the TV. 3 Turn on your player, then press PSCAN/NORMAL to select P-SCAN or Interlace. If the TV is a high-definition or progressive scan capable TV, select P-SCAN. If the TV is an older, "analog" TV, select Interlace. 4 Turn on the TV, then select the appropriate input source. For more information, see the documentation that came with the TV. Selecting the video output mode You need to set the video output mode on your player to match the TV video type. If you connect a TV using the S-Video jack, select S-VIDEO. If you connect a TV using the component jacks, select P-SCAN if the TV is a high-definition or progressive scan capable TV or select Interlace if the TV is an older, "analog" TV. To select the video output mode: 1 Press SETUP. The on-screen menu opens. SYSTEM SETUP TV SYSTEM SCREEN SAVER VIDEO TV TYPE PASSWORD RATING DEFAULT LAST MEMORY 2 Press or to select VIDEO, then press ENTER. 3 Press or to select the TV video type, then press ENTER. 4 Press SETUP to close the menu. www.insignia-products.com 5