Insignia NS-DA1902 User Manual (English) - Page 14

07-324 NS-BTHDP reduced.fm Page 12 Friday, August 3, 2007 1:29 PM NS-BTHDP/NS-BTHDST 5 After pairing and connection have succeeded, a short, high tone plays, and the blue indicator light flashes. The headset is now ready for use. The Insignia Bluetooth Stereo headset will automatically reconnect to the last-connected phone / device. If the connection is failed due to phone / device not found, the headset will automatically enter into pairing mode. Pairing with MP3 players and other devices You will need to pair your headset with Bluetooth-enabled devices, such as MP3 players, for it to work. Your headset headset can be paired with up to eight compatible phones or devices. However, it can only be connected to one phone at a time. Pairing the headset with Bluetooth-enabled devices To pair the headset with other Bluetooth devices: 1 Make sure that the headset is off. Press and hold the Multifunction button for more than seven seconds, until short, low tones come from the earpiece and the blue and red lights flash alternately. 2 Refer to the user guide of the device to set it into pairing mode. 3 When the device finds the headset, "NS-BTHDST" or "NS-BTHDP" appear. Accept and confirm the message by entering the keycode 0000 (four zeros). 4 After pairing and connection are finished, a short, high-tone beep plays, and a blue light flashes. The headset is now ready for use. Connecting with two devices simultaneously It is possible to connect the Insignia Bluetooth Stereo headset to two devices at the same time, so that you can listen to music and keep phone connectivity at the same time. 12 www.insignia-products.com