Insignia NS-DXFL2N User Manual (English) - Page 17
Troubleshooting
View all Insignia NS-DXFL2N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
NS-DXFL2N External TTL Flash for Nikon™ Troubleshooting Problem Solution The flash does not charge The flash does not fire The power turns off by itself Auto zoom does not work The picture is underexposed or overexposed Photos have dark corners or only parts of the target subject are illuminated • Make sure that the batteries are installed in the correct direction. • If appears and blinks on the back of the flash, replace the batteries immediately. • Install the batteries even when using an external power source. • Make sure that you are using Alkaline or NiMH AA batteries. • Make sure that the flash's mounting foot is securely connected to the camera's hot shoe. • Wait until the flash is fully charged and the flash ready indicator lights red. • Make sure that the electrical contacts on the mounting foot and hot shoe are clean. • Make sure that the camera's flash is turned on and the mode is active. • If the flash ready indicator does not light, replace the batteries. • If appears and blinks on the back of the flash, replace the batteries immediately. • If the flash is used in slave mode, make sure that the master flash on the camera is turned on and active. • If the flash is used in slave mode, make sure that there is a clear line of sight between the optic slave sensor and the camera's flash. • If using a PC sync cable, make sure your connections are secure. • The over-temperature protection may have temporarily disabled the flash. Wait 10 minutes and try again. • When the flash is set as the master unit, the flash enters sleep mode after 90 seconds of inactivity. Press the shutter button halfway or press the TEST button to wake it up. • When the flash is set as the slave unit, the flash enters sleep mode after 60 minutes of inactivity. Press the TEST button to wake it up. • Make sure that the camera is not set to manual zoom mode. • Make sure that the flash's mounting foot is securely connected to the camera's hot shoe. • If appears and blinks on the back of the flash, replace the batteries immediately. • If there is a highly reflective object (such as glass or a mirror) in the picture, use the FE lock. • If you are using the high-speed sync, make sure that the subject is within the effective flash range displayed. • If you are using Manual Flash mode, set the flash to TTL or modify the flash output. Make sure that the flash exposure compensation is set to zero. • Check the flash coverage you set. This flash unit has flash coverage between 24 and 105 mm (lens focal length), which fits medium-format cameras. Pull the wide panel out to extend the flash coverage. www.insigniaproducts.com 17