Insignia NS-LCD26F User Manual (English) - Page 7

Insignia NS-LCD26F/NS-LCD32F LCD TV Note Objects between the remote control and the sensor may weaken the remote control's IR signal. Range can be diminished by direct sunlight shining on the TV's IR sensor. Cautions Do not expose the remote control to liquids, direct sunlight, or shock. The remote control may not work correctly if the TV's IR sensor is under direct sunlight or strong lighting. In these cases, change the angle of the lighting or the TV screen, or operate the remote control closer to the IR sensor. Connecting to video sources Connecting to an antenna or cable/satellite receiver To connect an external antenna or cable/ satellite receiver: 1 Connect the antenna cable from an antenna or cable/satellite receiver to the antenna input jack on the TV. 2 Press the INPUT button to set the TV's signal input to TV. Notes • • To improve picture quality in a poor signal area, you can purchase and install a signal amplifier. To split the signal from an antenna, you will need a 2-way signal splitter. Connecting to a VCR 2 Connect RCA video and audio cables from the DVD player to the VIDEO and AUDIO IN jacks on the back of your TV. • Yellow - Video • White - Audio left • Red - Audio right - OR Connect an S-Video cable and audio cables from the DVD player to the S-VIDEO and AUDIO IN (L and R) jacks on the back of your TV. • White - Audio left • Red - Audio right - OR Connect RCA cables to the DVD's COMPONENT VIDEO Out jacks and the AUDIO OUT jacks (L and R), then to the COMPONENT IN jacks (Y, Cb/Pb, and Cr/Pr) and the AUDIO IN (L and R) jacks on the back of the TV. To connect your TV to a VCR: 1 Turn off the TV and the VCR (or other source). 2 Connect an RF cable to the VCR, then to the ANT. jack on the back of the TV. 3 Connect RCA audio cables to the VCR's audio output jacks, then to the AV IN L and R jacks on the back of the TV. 4 Turn on the TV and the VCR. 5 Press the INPUT button to set the TV's signal input to TV. Connecting to a DVD or other video source To connect your TV to a DVD or other video source: 1 Turn off the TV and the DVD (or other source). 3 Turn on the TV and the VCR. 4 Press the INPUT button to set the TV's signal input to S-VIDEO or YPbPr (as appropriate). To connect your TV to a DVD player with an HDMI cable: 1 Turn off the TV and the DVD player. 2 Connect an HDMI cable to the HDMI output jack on the DVD player, then connect it to the HDMI jack on your TV. www.insignia-products.com 5